Modbus Tcp - Lenze i550 Montage- Und Einschaltanleitung

Electrical installation
Networks

Modbus TCP

Modbus TCP
Typical topologies
M
S1
M Master
S Slave
Bus-related information
Name
Communication medium
Use
Connection system
Status display
Connection designation
Status displays at the RJ45 sockets
The LEDs at the RJ45 sockets indicate the connection status to the network:
LED "Link" (green)
off
on
LED "Activity" (yellow)
off
on or flickers
Basic network settings
The rotary encoder switch allows you to set the last byte of the IP address.
Setting
0x00
0x01 ... 0xFE
0xFF
176
Line
R
Sn
S2
Modbus TCP
Ethernet 10 Mbps, 100 Mbps, half
duplex, full duplex
Connection of the inverter to a
Modbus TCP network
RJ45
2 LEDs
Port 1: X276
Port 2: X277
Status/meaning
No connection to the network.
A physical connection to the network is available.
Status/meaning
No data transfer.
Data is exchanged via the network.
x16
Value of last byte
Value from parameter
Switch position
Default setting
SW1
SW Switch
x1
Resulting IP address
Value from parameter
192.168.124.<switch position>
192.168.124.16
Tree
M
SWn
SW2