Application As Directed; Handling - Lenze i550 Montage- Und Einschaltanleitung

Application as directed

• The product must only be operated under the operating conditions prescribed in this documentation.
• The product meets the protection requirements of 2014/35/EU: Low-Voltage Directive.
• The product is not a machine in terms of 2006/42/EU: Machinery Directive.
• Commissioning or starting the operation as directed of a machine with the product is not permitted until
it has been ensured that the machine meets the regulations of the EU Directive 2006/42/EU: Machinery
Directive; observe EN 60204−1.
• Commissioning or starting operation as directed is only permissible if the EMC Directive 2014/30/EU is
complied with.
• The harmonised standard EN 61800−5−1 is applied.
• The product is not a household appliance, but is only designed as a component for commercial or
professional use in terms of EN 61000−3−2.
• The product can be used according to the technical data if drive systems have to comply with categories
according to EN 61800−3.
In residential areas, the product may cause EMC interferences. The operator is responsible for taking
interference suppression measures.
• The product must only be actuated with motors that are suitable for the operation with inverters.
- Lenze L-force motors meet the requirements
- Exception: m240 motors are designed for mains operation only.
The user is not allowed to change inverters that come with integrated safety technology.
The safety module must not be removed. If the safety module is defective, the inverter has to be replaced.

Handling

• Never commission the product in the event of visible damage.
• The product must never be technically modified.
• Never commission the product before assembly has been completed.
• The product must never be operated without required covers.
• Establish, separate and change all electrical connections only in deenergised state!
Safety instructions
Handling
113