Change Wet Grinding Disc; Cleaning And Maintenance; Cleaning - Parkside PNTS 250 A1 Originalbetriebsanleitung

GB
The grinding disc nut must not be
screwed too tightly in order to
avoid a breaking of the grinding
disc and nut.
8. Test run:
Before starting work and after each
change of grinding disc, carry out a
test run of at least 60 seconds with no
load. Switch off the equipment immedi-
ately if the disc runs lumpy, substantial
vibrations occur, or abnormal noises
are generated.

Change wet grinding disc

1. Loosen the 3 fixing screws
(13a/13b/13c) and remove the
water tank (13).
2. Unscrew the grinding disc nut (22)
with a screw wrench (SW19) and
hold against the grinding disc
( 1)with one hand wearing a
glove. Unscrew the nut (right-hand
thread):
turn counter-clockwise.
3. Remove the washer (26) with a
plastic clamping flange (27) and
the grinding disc (
4. Fit on the new grinding disc (1)
and the plastic clamping flange
(27) with the washer and screw
the grinding disc nut (22) manu-
ally onto the right-side nut (right-
hand thread):
turn clockwise.
The two plastic clamping flanges
(27/28) are not identical.
5. Tighten the grinding disc nut with
a screw wrench (SW19) applying
modest manual force.
64
8. Test run:
Cleaning and
maintenance
1).

Cleaning

6. Push the water tank back over the
wet grinding disc and onto the
gear unit housing (29).
7. Fasten the water tank (
back on the gear unit housing
(29) using the three screws.
The grinding disc nut must not be
screwed too tightly in order to
avoid a breaking of the grinding
disc and nut.
Before starting work and after each
change of grinding disc, carry out a
test run of at least 60 seconds with no
load. Switch off the equipment immedi-
ately if the disc runs lumpy, substantial
vibrations occur, or abnormal noises
are generated.
Disconnect the plug before adjust-
ment, maintenance or repair.
Have any work not described
in these instructions carried
out by a specialist workshop.
Use only original components.
Allow the equipment to cool
before carrying out any main-
tenance and cleaning work.
There is a risk of burns.
Do not use cleaning agents or sol-
vents. Chemical substances may
attack plastic parts of the equipment.
Never clean the equipment under
running water.
13)