Reversing The Door - EdilKamin SCREEN 80 Installations-, Betriebs- Und Wartungsanleitung

INSTALLATION INSTRUCTIONS

Reversing the door

The SCREEN fireplace is manufactured with the door hinged on the
left hand side. When installing the fireplace in corners or in spaces
which require special installation characteristics, it may be necessary
to hinge the door on the opposite side. The direction in which the
door of the SCREEN fireplace opens can be reversed by following
the simple procedure below:
1) Open the door and unthread the upper pin using a flat screwdri-
ver (Fig. 1).
2) With one hand hold the door and with the other unthread the
pin.
3) Lift the door by unthreading it from the lower eccentric pin and
pull the door out without removing the spring. Whilst doing this, do
not place your hand on the lower part of the door in order to avoid
being hit by the spring (Fig. 2).
4) Loosen the grub screw on the lower pin (Fig. 3).
5) Loosen the eccentric pin and mount it on the opposite side, repe-
ating the operations in the opposite order (Fig. 4).
6) Unthread the spring from the door and mount it on the opposite
side.
7) Set the door in place onto the lower eccentric pin by fitting the
lower part of the spring into the hole.
8) Set the door in place by using the upper pin.
9) Close the door and its opening direction is set.
This procedure must be implemented by a qualified
technician as implementing this incorrectly can prevent
the door from closing completely and the door can even
break or the components ruined!
- 22
-
fig.1
fig.2
fig.3
fig.2
fig.4