Handling And Operation; Before Initial Use; Operation - Silvercrest SPM 2000 D2 Bedienungsanleitung

Handling and operation

This section provides you with important information on handling and using the
appliance .

Before initial use

♦ Clean all accessories as described in the section "Cleaning and care" to
remove any possible production residues .
♦ Read these operating instructions carefully .
♦ Set up the appliance in accordance with the safety instructions .
♦ Open the safety catch 4 by moving the slider from the
the position .
♦ Clean the appliance with a damp cloth as described in "Cleaning and Care" .
♦ Close the appliance .
♦ Insert the mains cable plug 3 in a properly connected and earthed mains
power socket which supplies the voltage stated in the"Technical data" section .
Allow the appliance to heat up for about 5 minutes on the maximum temperature
setting by turning the heat level control 2 as far as the right-hand stop .
NOTE
► The first time the appliance heats up, a small amount of smoke and odour
may be generated due to production-related residue . This is normal and is
completely harmless . Provide sufficient ventilation; for example, by opening
a window .
♦ After heating, pull the plug 3 out of the mains socket and allow the appliance to
cool down completely .
♦ Clean the appliance again with a damp cloth .

Operation

♦ Close the appliance lid using the handle 6 .
♦ Slide the fat collector tray 7 into the appliance .
♦ Replace the plug 3 in the mains mains power socket . Replace the plug in the
mains power socket . The green control lamp "Ready" 5 lights up when the heat
level control 2 is set to "MIN" or lower . The appliance does not heat up in this
setting .
♦ Set the desired level on the heat level control 2 . The green "Ready" control lamp 5
goes out and the red "Power" control light 1 lights up . As soon as the set heating
level has been reached, the red "Power" control light 1 goes out and the green
"Ready" control lamp 5 lights up again .
SPM 2000 D2
position to
│ 27 ■
GB │ IE