Handling And Operation; Before Initial Use; Operation - Silvercrest SPM 2000 C2 Bedienungsanleitung

Handling and operation

This section provides you with important information on handling and using the
appliance.

Before initial use

♦ Clean all accessories as described in the section "Cleaning" to remove any
possible production residues.
♦ Read these operating instructions carefully.
♦ Set up the appliance in accordance with the safety instructions.
♦ Open the safety catch
position.
♦ Clean the appliance with a damp cloth as described in "Cleaning and Care".
♦ Close the appliance.
♦ Insert the mains cable plug
power socket which supplies the voltage stated in the"Technical data" section.
Allow the appliance to heat up for about 5 minutes on the maximum temperature
setting by turning the heat level control
NOTE
► The first time the appliance heats up, a small amount of smoke and odour
may be generated due to production-related residue. This is normal and is
completely harmless. Provide sufficient ventilation; for example, by opening
a window.
♦ After heating, pull the plug out of the mains socket and allow the appliance to
cool down completely.
♦ Clean the appliance again with a damp cloth.

Operation

♦ Close the appliance lid using the handle
♦ Slide the fat collector tray
♦ Replace the plug in the mains mains power socket. The green "Ready" control
lamp
♦ Set the desired level on the heat level control
goes out and the red "Power" control light
level has been reached, the red "Power" control light
"Ready" control lamp
SPM 2000 C2
by moving the slider from the
into the appliance.
lights up when the heat level control
lights up again.
in a properly connected and earthed mains
as far as the right-hand stop.
.
is set to "0" (
. The green "Ready" control lamp
lights up. As soon as the set heating
position to the
•
).
goes out and the green
GB │ CY
│ 9 ■