Maintenance Plan - Summary Table - Gaspardo RENATA MARISA Gebrauch Und Wartung

6.1 MAINTENANCE PLAN - Summary table

INTERVAL
WHEN THE MACHINE lS NEW
AT THE BIGINNING OF
THE SEEDING SEASON
EVERY 8 WORKING HOURS
EVERY 50 WORKING HOURS
cod. G19503482
- Grease all parts indicated by transfer nr. 19 ('GRASE') at page 55 of this leafl et.
- Lubricate all the transmission chains with mineral oil (SAE 80W/90).
- After the fi rst hours of work check that all the bolts are still tight.
WARNING! Do not over-tighten the screws holding the case (C, Fig. 70). It should be able
to oscillate.
- Check the pressure of the tyres (see technical data table).
- Lubricate all the transmission chains with mineral oil (SAE 80W/90).
- Check the fi xing and the state of wear of all the suction tubes and the delivery tubes for
fertilizer and other chemical products.
- Run the seeding machine loadless, the airfl ow clears the pipes of condensation and removes
any impurities.
- Grease the disc coulters (1, Fig. 70).
- Check the tensioning of the aspirator belt (Fig. 34).
- Lubricate all the transmission chains with mineral oil (SAE 80W/90).
- Grease the pin of the seeding depth control wheels (2, Fig. 70).
- Grease the universal joint spiders.
- Grease the bevel gear pair of the cardan shaft of the planting units (4, Fig. 70).
- Inspect the condition of the seed plates; if any of the pegs are missing or bent, replace the
plate with an original spare; if there are circular scratches on the plates they must not exceed
1/3 of the disc thickness.
- Clean the seed distributor carefully and thoroughly; replace the cover seal if necessary.
- Check the tensioning of the aspirator belt (Fig. 34).
- Make sure the toothed wheels are properly aligned and the transmission chains are tensioned
to prevent them from wearing out in little time or a failure affecting the transmission parts.
- Check that all the bolts are still tight.
- Grease all the joints of the row marker shown in Figure 69.
- Grease all frame joints indicated in Figure 71-72.
- Grease all the wheel joints shown in Figure 73.
- To load the hydraulic system of oil of the side wings (see chap. 4.4.1).
fi g. 69
4
C
USE AND MAINTENANCE
TYPE OF WORK
3
1
fi g. 70
fi g. 72
2
fi g. 73
ENGLISH
fi g. 71
EN - 91