Removing The Bicycle - Elite REALPOWER Bedienungsanleitung

The console stores the reference of the USB key
with which it is supplied, and therefore cannot
work with other wireless USB keys (even if by
Elite).
If the console has to be used with another USB
key, it is necessary to do a reset which enables the
connection with other Elite USB keys.
Reset procedure
To unlock the console, press the keys: Up arrow,
Down arrow and Enter together. When the
procedure is completed, the three LED's light up
and go off twice to signal correct execution of the
unlock procedure.
Note:
The presence of high-voltage electric lines,
traffic lights, electric railway lines, bus or tram
electric lines, television sets, automobiles, cycle
computers, gym equipment and mobile phones
inside the operating range of the console, etc., can
be the cause of interference.
Therefore the use of other wireless receivers
may alter or completely inhibit operation of the
Wireless Console due to such interference.

REMOVING THE BICYCLE

To remove the bicycle, proceed as follows:
• Remove the console from the handlebar.
• Move the small roller of the resistance unit
away from the tyre, turning the knob of the unit's
support plate counterclockwise.
• Disconnect the power supply to the roller,
removing the power adapter jack from the
resistance unit.
• If installed, remove the cadence sensor from the
bicycle. Otherwise it is possible to also remove the
magnet from the pedal crank.
• Lift the stand locking lever with one hand, while
holding the bicycle saddle without the other so
that the bicycle does not fall over.
• Lift the bicycle and move it from the stand.
• The stand can then be closed so that it takes up
less space. In this case it is advisable to remove
all the cables and put them in a dry place together
with the console and USB key (Ref. 37).
• During long periods of inactivity and in case of
long travels, it is advisable to completely remove
the resistance unit from the trainer base and store
it in it's original packaging.
EN
35
36
37
33