Fitting The Console On The Handlebar; Fitting The Cadence Sensor; Connections; Wireless Console - Pc Connection - Elite REALPOWER Bedienungsanleitung

EN
FITTING THE CONSOLE ON THE
HANDLEBAR
The console can be fit in two different positions, on
the handlebar of the bicycle (see figure 29) or on
the handlebar stem (see figure 30).
To fix the Wireless console to the handlebar of the
bicycle, just place it on the tube and secure it with
the two rubbers provided, wrapping the handlebar
tube and clamping the two rubbers on the teeth
located on the back of the console.
To fix the Wireless console to the handlebar stem,
it is necessary to use the adapter included (ref. K).
The adapter must be fixed to the console in place
of the two rubbers. Therefore remove the two
rubbers, undoing the screws fixing them to the
console. Then position the adapter in place of
the 2 rubbers (see image 31) and fix it with the
two screws included (ref. Q). Insert the rubbers in
the special spaces in the adapter (see image 31)
and secure them with the two screws used to fix
them.
When fixing the Wireless console to the handlebar
or to the tube, make sure to keep a sufficient space
under the console for connection of the 8-core
cable (ref. L) connecting the Wireless console to
the roller.
30
29

FITTING THE CADENCE SENSOR

The cadence sensor (Ref.H) enables the number
of pushes on the pedals per minute to be counted
during the race.
The installation instructions are given on the
"Cadence Sensor Instructions" sheet.
30
Note. The cadence sensor does not have to be
fitted in order to use the roller and relevant
software. In this case, the programme will not
indicate the pedalling cadence value.

CONNECTIONS

NOTE: DO NOT INSERT THE USB KEY IN
THE COMPUTER BEFORE INSTALLING THE
REALPOWER PROGRAMME.
Wireless Console – Pc Connection
The RealPower console uses radio technology for
exchanging information with the PC. To enable
the exchange of data with the PC, it is necessary
to use the USB key (ref. D). This USB key must be
inserted in one of the PC's USB ports.
ATTENTION: DO NOT INSERT THE USB KEY
IN THE COMPUTER BEFORE INSTALLING THE
REALPOWER PROGRAMME.
The maximum connection distance between the
PC and console in optimum conditions and in
31