Led For Operating State Of Cf Card; Microphone Input, Loudspeaker Output - HBM QuantumX CX22-W Bedienungsanleitung

QuantumX Data Recorder CX22‐W
Set the outputs via the limit value and event monitoring: Enter 0 HIGH (LED4)
under Bit/Condition if output 4 should become active when the event occurs
(LED 4 lights up green). Outputs 5 and 6 are activated via Bit 1 (LED 5) and
Bit 2 (LED 6).
Tip
At the start of a DAQ job, outputs are reset to LOW if you activate the setting
Reset all CX22 digital outputs on DAQ start in the Options for the CX22‐W
(group System) in catman

10.3.5LED for operating state of CF card

The LED on the rear of the module flashes yellow when data are written to or
read from the CF card.

10.4 Microphone input, loudspeaker output

The microphone input allows you to connect a standard PC microphone
(powered by the CX22‐W).
Fig. 10.1: Microphone input pin assignment
You can either connect an active PC loudspeaker/headphones to the loud­
speaker output or you can feed the signal as Line‐Out to a (HiFi) amplifier.
Fig. 10.2: Loudspeaker output pin assignment
A3169-1.0 en/de
®
AP.
Microphone power supply
Microphone signal
Ground
Left
Right
Ground
37
HBM