Procedure For Inserting The Cf Card - HBM QuantumX CX22-W Bedienungsanleitung

QuantumX Data Recorder CX22‐W

4.2 Procedure for inserting the CF card

The CF card must be formatted with the NTFS file system. You can carry out
this formatting with any PC that has a CF card slot or a CF card adapter and
uses Windows XP or higher.
NOTE
Switch the CX22‐W off before replacing the CF card. Otherwise the CX22‐W
or the CF card could be damaged or, if measurement data are being recorded,
this could cause all the data of the test to be lost.
1. Unless otherwise already implemented, undo the retaining screw of the
CF card slot (Fig. 3.2 on Page 12) and swivel the cover plate upwards.
The screw must not be removed, it should just be loosened.
2. Hold the CF card with the top facing upwards.
3. Slide the CF card into the slot until you feel a slight resistance at the end
when the contacts slide into the internal contact strip. The CF card must
disappear completely inside the slot.
4. Swivel the cover plate down until it engages in the protective casing
recess and the slot is covered.
5. Tighten the retaining screw by hand.
A3169-1.0 en/de
15
HBM