Changing The Compactflash Card; Procedure For Removing The Cf Card - HBM QuantumX CX22-W Bedienungsanleitung

14
4

Changing the CompactFlash card

Important
CompactFlash cards (CF cards) only have a limited number of write cycles,
i.e., they age (typically 1,000,000 write cycles). You should therefore check
the CF card regularly for errors in Windows and replace with a new card
where necessary. The service life of a CF card depends on the loading and
the manufacturer.
Ensure that a current, high quality CF card, type 1, CF version 4.1 is used
with at least 8 GBytes so that a high data rate can be achieved; older CF
cards usually have lower data rates. The card must be formatted with the
NTFS file system before insertion.
An 8 GByte CF card is included in the scope of delivery of the CX22‐W Data
Recorder.

4.1 Procedure for removing the CF card

NOTE
Do not replace the CF card when the CX22‐W is switched on.
This could damage the CX22‐W or the CF card or, if measurement data are
being recorded, this could cause all the data of the test to be lost.
Switch the CX22‐W off before replacing the CF card.
1. Undo the retaining screw for the CF card (Fig. 3.2 on Page 12). The
screw must not be removed, it should just be loosened.
2. Swivel the cover plate upwards to expose the slot for the CF card.
3. Use a blunt object, e. g. a ball‐point pen to press the ejection button on the
right in the CF card slot (Fig. 3.2).
4. Remove the CF card.
5. Read Section 4.2, this describes the insertion of the CF card. The
CX22‐W should not be operated without a CF card, as no data can be
stored.
HBM
QuantumX Data Recorder CX22‐W
A3169-1.0 en/de