The Cx22-W Data Recorder Start Screen - HBM QuantumX CX22-W Bedienungsanleitung

QuantumX Data Recorder CX22‐W
7 The CX22‐W Data Recorder start screen
In the CX22 start screen you can:
1. Start the catman
Also refer to Chapter 9 for automatic start.
2. Change important CX22‐W settings: Settings.
You can use this to change, e.g. the device name and password, as well
as the catman
installed software and hardware. See Section 11.1 on Page 39.
3. Permanently store configuration changes: Commit changes and reboot.
You must always click on this button if you have implemented any
changes via the Settings button or in System (Windows).
4. Terminate the Remote Desktop Connection: Terminate remote session.
You can also terminate a connection by closing the Remote Desktop win­
dow.
5. Switch to the system level (Windows): Exit to Windows.
This is necessary, e.g. when you want to activate the CX22‐W WLAN. See
Section 6.3 on Page 23.
6. Switch off the CX22‐W Data Recorder: Shutdown.
This switches off the CX22‐W. Interrupt the power supply for approx. 5
seconds to switch it back on again.
A3169-1.0 en/de
®
AP program: Start DAQ software.
®
AP language. The Info tab contains information about the
29
HBM