HBM QuantumX CX22-W Bedienungsanleitung Seite 31

QuantumX Data Recorder CX22‐W
3. If you are not using transducers with TEDS, assign the connected sensors
(transducers) to the channels: Find your sensors in the sensor list (Com­
ponent window Sensor database), then Drag&Drop each sensor to the
channel it is connected to. If necessary, set up your sensors in the sensor
database.
4. Assign unique channel names.
You can generate channel names with sequential numbering or accept the
sensor designation via the context menu Rename. Each channel is identi­
fied in catman
names where possible.
5. Mark the channels to be set to zero and run a zero adjustment (Zero bal­
ance, group Zero balance).
6. Deactivate unused channels if necessary (group General, Active: Deac­
tivate all channels without sensor).
7. Define - if required - calculations: Create in the group Computation
channels.
8. Activate Live readings (tab DAQ channels, group General) to display
continuous measured values and check that all channels are working cor­
rectly.
9. Go to the DAQ jobs tab.
10. Select your measurement conditions: Sample rate, DAQ start and stop.
Select DAQ start via Trigger and Digital input in Trigger mode in order
to use the digital inputs or the START/STOP button of the CX22‐W (also
see Sections 10.1 and 10.2 on Page 35).
11. Click on Data storage (group Settings) and set the settings for saving the
data after or during measurement. We recommend using the setting Auto­
matically on DAQ termination for Data saving. Otherwise a monitor
must be connected during measurement in order to save the data.
12. Create visualization if a monitor is connected.
13. Save your measurement project: File menu -> Save -> Project.
14. Start your measurement project via Start DAQ in the group Measure­
ment.
If you have not created a visualization you will be asked if one of the
default settings for visualization should be used. Click on Measure
without visualization if a monitor is not connected during measurement.
The measurement mode of the CX22‐W is activated and - if you have
defined a start trigger, e.g. the START/STOP button - waits for the trigger.
The "RECORDING" LED flashes while waiting for the start trigger and
lights up continuously as soon as measurement starts.
A3169-1.0 en/de
®
AP by its name, you should therefore use meaningful
31
HBM