HBM QuantumX CX22-W Bedienungsanleitung Seite 22

22
6. The IP addresses and subnet masks of the PC interfaces are displayed in
the Settings of my computer section on the left side.
You now have two options, dependent on your network: You can either
give the CX22‐W a permanent address or set the CX22‐W Data Recorder
to DHCP.
7. Select the CX22‐W in the top list.
8. Click in the field TCP/IP‐Settings for CX22 on LAN and enter the
required IP address and subnet mask or select Use DHCP.
An address and subnet mask that lie within the address range of your PC
are automatically proposed, you can however change this proposal.
Please note the specifications of your network administrator.
9. Click on Apply and wait until the new setting is shown at the top. The
symbol should change to the symbol
nection is possible.
10. If necessary, select the CX22‐W again in the top list and then click on
Remote connect using LAN.
11. If Windows queries whether a connection to the remote computer should
be set up, confirm the connection. We recommend activating the option
Do not ask about connection to this computer again. Depending on
the configuration of your Windows operating system, another query as to
whether the connection should be set up may be displayed (identity of the
remote computer). If necessary, activate the option to prevent the query.
The connection with the CX22‐W Data Recorder will now be implemented
and you must register with the device via Windows. Enter HBMCX22 as
the User name and hbm as the Password. The text for the Password
must be in lower case.
Important
The IP address and subnet mask or the DHCP setting are not yet saved. In
the start screen, click on Commit changes and reboot to permanently save
the new settings. The CX22‐W is then rebooted, you must therefore set up the
connection again after the new start. (Wait approx. 1 minute until the CX22‐W
has rebooted before clicking on Remote connect using LAN.)
HBM
QuantumX Data Recorder CX22‐W
and thereby indicate that a con­
A3169-1.0 en/de