Footrest Assembly For Seating Shell Interface; Seating Shell Interface - Ottobock Discovery Gebrauchsanweisung

Accessories
Figure 25 Figure 26
Adjusting the Angle of the Footplate (Fig. 25)
Angle adjustable footplates are included as standard equipment.
Loosen the Allen head screw (wrench size 5 mm) at the rear footplate suspension by several turns.
Adjust the footplate to the desired position and firmly re-tighten the screw.
Attention – To ensure perfect function of the single-panel footrest, the angle on the hinged side and on the
resting side must be identical.
Locking Device for Single-panel Footrest (Fig. 26)
The locking device prevents inadvertent loosening and flipping-up of the footplate, especially with spastic users.
Pull the bar at the ring (Fig. 26) to flip the footplate up.
After you have finished all adjustments make sure to re-tighten any screws you have undone.
A
A
B
B
Figure 27 Figure 28
Footrest Assembly for Seating Shell Interface (Fig. 27)
The footrest assembly is mounted to the seating shell interface. To do this, loosen the Allen head screws at the
seating shell interface (Fig. 27, item A) and move the knee angle to the desired position. Firmly re-tighten the
Allen head screws.
The knee angle can be adjusted using the clamping lever (Fig. 27, item B).
The Allen head screws (Fig. 28, item A) allow adaptation to the lower leg length.
To adjust the angle of the footplate undo the two screw connections (Fig. 28, item B) on the left and right of the
footplate.
When making adjustments, always make sure that the footplate does not contact the caster.
'Horacek' Seating Shell Interface (Fig. 27)
The seating shell interface easily attaches to the 'Horacek' interface adapter by means of the quick-release lock.
The seating shell interface is attached underneath the seating system. For the handling, please refer to section
'Removing and Mounting Seating Systems Equipped with the 'Horacek' Seating Shell Interface'.
32 | Ottobock Discovery