Mounting And Installation Instructions - ECOLAB Elados EMP III Typ E00 Betriebsanleitung

Assembly, mounting and installation
Risk due to electrical energy
DANGER!
Risk of fatal injury from electric current!
Contact with live parts represents immediate danger to life due to electrocution.
Damage to the insulation or individual components can be life-threatening.
– Before starting work, create a de-energised state and ensure this state for
the duration of the work.
– Work on electrical components may only be carried out by professional
electricians.
– Turn off immediately and organise repairs if there is any damage to the
insulation voltage supply.
– Never bridge or decommission fuses.
– When replacing fuses, observe the correct rating.
– Keep voltage-carrying parts away from moisture, as this can cause a short
circuit.
Personal protective equipment
DANGER!
Personal protective equipment, hereinafter referred to as PPE, is used to
protect personnel. The personnel who set up and install the pump must use
suitable PPE to protect against injury.

Mounting and Installation Instructions

CAUTION!
– Setup, installation and mounting work are to be performed exclusively by
authorised, trained and approved experts in compliance with prevailing
general guidelines and local regulations.
– Special measures and protective equipment for metering hazardous or
aggressive chemicals are not listed here.
– When using them, it is imperative that you observe the statutory regulations
and the pertinent product data sheet for the metering medium being used.
417102233 Rev. 3-03.2019 26