Environmental Protection Measures; Obligations Of The Operator - ECOLAB Elados EMP III Typ E00 Betriebsanleitung

Safety
Hazards caused by pressurised components
DANGER!
Danger of injury from pressurised components!
With improper handling, pressurised components can move uncontrollably and
cause severe injuries. Liquid under high pressure can escape from pressurised
components if handled improperly or in the case of a defect. This can lead to
severe or fatal injuries.
– Establish a pressure-free state.
– Discharge any residual energy.
– Make sure that liquids cannot discharge accidentally.
– Immediately call in qualified staff to replace defective components which
are pressurised during operation.
2.7.3

Environmental protection measures

ENVIRONMENT!
The environmental symbol denotes environmental protection measures.
2.8

Obligations of the operator

In the EEA (European Economic Area), national implementation of the
Directive (89/391/EEC) and corresponding individual directives, in particular
the Directive (2009/104/EC) concerning the minimum safety and health
requirements for the use of work equipment by workers at work, as amended,
are to be observed and adhered to.
The operator must adhere to the local legal provisions for:
n personnel safety (employers' insurance association and accident prevention
regulations, workplace directives), e.g. operating instructions, including those in
accordance with Section 20 Hazardous Substances Ordinance (GefStoffV), personal
protective equipment (PPE), health screening;
n safety of work materials and tools (protective equipment, work instructions, procedural
risks and maintenance);
n product procurement (safety data sheets, list of hazardous substances);
n disposal of products (Waste Act);
n disposal of materials (decommissioning, Waste Act);
cleaning (detergents and disposal);
n
n as well as complying with current environment protection regulations.
417102233 Rev. 3-03.2019 20