Setting The Pump; Factory Setting; Control Panel - Grundfos MAGNA 40-120 Montage- Und Betriebsanleitung

8. Setting the pump

For the setting of the pump, use:
•

control panel

• R100 remote control
• bus communication (not described in detail in
these instructions, contact Grundfos).
The table shows the application of the individual
operating units and in which section the function has
been described.
Possible settings
AUTO
ADAPT
Automatic night-time duty
Proportional-pressure
control
Constant-pressure control
Setpoint setting
Max. curve duty
Min. curve duty
Constant-curve duty
Temperature influence
Activation/deactivation of
pump buttons
Allocation of pump number
Start/stop
Resetting of fault
indications
Reading of various data
"–" = not available with this operating unit.

8.1 Factory setting

The pump is factory-set to AUTO
automatic night-time duty.
20
8.2 Control panel
The control panel, fig. 19, incorporates:
8.2.1 8.7.1
8.2.1 8.7.2
8.2.1 8.7.1
8.2.1 8.7.1
For further information, see section 9. Fault finding
8.2.2 8.5.1
chart.
8.2.3 8.5.2
8.2.4 8.5.2
– 8.5.2
– 8.7.3
– 8.7.4
– 8.7.6
8.2.5 8.5.2
8.2.6 8.5.3
8.6.1 -
–
8.6.7
without
ADAPT
Warning
At high liquid temperatures, the pump
may be so hot that only the buttons
should be touched to avoid burns.
Pos. Description
1 Buttons for setting
• Indicator lights for operating and fault
indication and
2
• symbol for indication of external control
3 Button for change of control mode
Light symbols for indication of control
4
mode and night-time duty
Light fields for indication of head, flow and
5
operating mode
Fig. 19 Control panel