Putting Into Operation - Beurer PM 110 Bedienungsanleitung

4. Putting into operation

4.1 Fitting the heart rate monitor in the glove holder and removing it
The heart rate monitor is already
pre-assembled on the glove holder
when you receive it. To activate the
batteries or to exchange or wash
the glove holder, you must sepa-
rate the measuring unit from the
measuring unit holder and from the
glove holder.
• Do this by detaching the measu-
ring unit holder from the glove
holder by carefully pulling the
Velcro fastener down.
• Open the Velcro straps at the
back of the measuring unit holder
and withdraw the measuring unit.
• Remove the sensor cable from the cable holder by pressing the cable holder apart with two fingers.
• Pull the sensor holder out of the sensor opening of the glove holder.
Reverse the above actions to fit the measuring unit on the meter unit holder and glove holder. Ensu-
re that the Velcro fasteners are securely attached and that the blue head of the optical finger sensor
is firmly inserted in the sensor opening.
4.2 Inserting the battery
Open the battery compartment cover at the back of the moni-
tor in the direction of the arrow using a coin or the battery. Do
not lose or damage the rubber ring in the battery compartment
and ensure that no dirt enters.
Insert a Type CR2032 battery with the plus pole "+"upwards.
Close the cover by alining up the two triangles and turning it
anti-clockwise.
1