Siemens SIMOVERT MASTERDRIVES Betriebsanleitung Seite 176

Installation
Removing the slot
cover
Removing the
optional board
Removing the
option card holder
Mounting the
optional board
NOTICE
5-8
♦ Remove the cover of the selected slot on the front panel.
♦ To do so, you must carefully cut through the four connecting points
of the cover on the front panel with a thin knife.
♦ Undo the two optional board screws by about one turn each.
♦ Loosen the connection between the system connector and the
board so as to prevent any mechanical tension arising when the
screws are fully unscrewed.
♦ Take out the optional board screws and remove the board.
Remove the fixing screws of the option card holder from the pins and lift
the option card holder from the device.
Optional boards can only be inserted in slot A and slot B. Slot C of the
unit is permanently pre-assigned for the terminal module EBV.
♦ Insert the optional board from the behind the broken-out slot conver
( ) until the position of the 64-pole system connector on the
electronic board corresponds with the position of the socket.
♦ Insert the option board into the 64-pole system connector on the
electronic board (
♦ Screw the optional board tight at the fastening points in the front
section of the optional board with the two screws (
Slot A
Slot B
Slot C
Fig. 5-7 Installing the optional board
).
Operating Instructions
02.2008
).
Slot B
Slot C
6SE7087-6JP60 Siemens AG
SIMOVERT MASTERDRIVES