Setting The Mowing Times; Intouch; Edge Mowing With A Manual Start - AL-KO Robolinho series Betriebsanleitung

Settings
Set entry point 1
8. or
start point has been specified during the
teaching-in movement. If no start point has
been specified here, the start points are auto-
matically specified.
Entry point x: XXm
9. or
the last start point has been reached.
Manually specifying start points (01)
The first start point (01/X0) is pre-set and is 1 m
to right of the base station. Up to 3 other start
points (X1 to X3) can be programmed behind this
point. When specifying the start points, heed the
following:
■
Do not set start points too far from the base
station or too close to one another (02/f).
■
Only use as many start points as necessary.
* Entry Point
1. or
* Point X1 at [020m]
2. or
Select one digit in sequence with
and accept accordingly with
* Point X2 at [075m]
3. or
Select one digit in sequence with
and respectively accept with
4. If necessary, specify further start points.
5. Return to the main menu with
7.3.3

Setting the mowing times

NOTE
There must be at least 30 min. between
programming the mowing times and the
mowing start. If not, the appliance only
starts at the next programmed mowing
time.
In the Weekly Program menu item, the days of
the week and time periods when the appliance
should mow are set. Adapt these settings to the
size of your garden if necessary. If unmown ar-
eas are still visible after approx. one week, in-
crease the mowing periods.
* Weekly Program
1. or
■
* All Days [X]: The appli-
or
ance mows every day at the set times. If
All Days [ ] is shown, the appliance
only mows on the set days of the week.
495053_a
■
if no
if
■
2. Make the settings for every day or the re-
spective day:
■
■
or
.
■
or
.
■
.
3.
tings of the menu item.
7.4
An existing connection to a gateway can be dis-
connected. This means the appliance is ready to
establish a new connection for 30 minutes.
1.
2. Reset connection
Appliance reports: Done.
3. Confirm with
7.5
* Monday [X]...* Sunday
or
[X]: The appliance mows for the set
time periods on the set day of the week.
If Monday [ ] is shown, for example,
the appliance does not mow on the re-
spective day.
Change
or
spective day [X] or deactivate it [ ],
and set the time periods, type of mowing
and the start points.
e.g. *[M] 07:00-10:00 [?]: Normal
mowing [M] from 07:00 – 10:00 am with
automatically changing start point 0 – 9
[?].
e.g. *[R] 16:00-18:00 [1]: The ap-
pliance starts with edge mowing [R] at 4
pm and moves along the entire boundary
cable. The area mowing then begins at
start point 1 [1]. At 6 pm or as soon as
the rechargeable battery is discharged,
the appliance moves back to the base
station.
Change
or
lected setting.
Continue
or
changes setting and continue to the next
setting.
Save
or : Save all changed set-

inTOUCH

NOTE
To establish a connection later, the con-
nection must first be disconnected
again, even if the appliance was not pre-
viously connected with a gateway.
*inTOUCH
or
and return to the menu.

Edge mowing with a manual start

: Activate the re-
: Change the se-
: Confirm the
51