Setting The Secondary Area Mowing; Setting The Display Contrast; Setting Lock; Recalibrating - AL-KO Robolinho series Betriebsanleitung

GB
For a manual start, the setting can be made here
that the appliance begins with edge mowing.
Carrying out the edge mowing at the pro-
grammed mowing time periods: see chapter 7.3.3
"Setting the mowing times", page 51.
* Margin mowing
1. or
* at manual start
2. or
7.6

Setting the secondary area mowing

* Sub zone mowing
1. or
2. Setting the mowing time periods:
■
inactive
or
Secondary area mowing is switched off.
■
active
or
The appliance mows until the recharge-
able battery is flat.
■
Mowing time in min
or
The appliance mows the secondary area
for the set time period. The following
mowing time periods can be set:
30/60/90/120/until rechargeable battery
flat.
7.7

Setting the display contrast

If the display is difficult to read, e.g. in sunlight,
the display can be improved by changing the dis-
play contrast.
* Display contrast
1. or
2. Increase/decrease the display contrast with
or and accept with
7.8

Setting lock

If the setting lock is deactivated, the PIN must on-
ly be entered when acknowledging safety-rele-
vant faults.
* Safety settings
1. or
2. Activating/deactivating the setting lock:
■
Activate
or
Activate the setting lock.
■
Deactivate
or
Deactivate the setting lock.
7.9

Recalibrating

If the position or length of the boundary cable has
been changed or the appliance no longer finds
the boundary cable, recalibration is necessary.
52
:
:
:
.
:
:
Reset calibration
1. or
2. Reset loop calibration data?
3. Carrying out a calibration movement: see
chapter 5.4 "Carrying out an automatic cali-
bration movement", page 49.

7.10 Restoring factory settings

The factory settings of the appliance can be re-
stored, e.g. before selling the appliance.
* Factory reset
1. or
Appliance reports: Factory reset com-
pleted

8 DISPLAYING INFORMATION

The Information menu is used for displaying
machine data. No settings can be made in this
menu.
1. Call up the main menu with
* Information
2. or
3. Select the menu item with
cept with .
Note: The menu items are described in the
following sections.
4. Return to the main menu with
Blades service
Shows in how many operating hours a blade ser-
vice is required. The counter can be reset manu-
ally. Have the blade service carried out by an AL-
KO dealer, technician or service partner.
Reset the counter for blade service:
Confirm
1. or
Hardware
Shows information on the appliance, such as
type, year of manufacture, operating hours, serial
number, number of mowing operations, total
mowing time, number of charging cycles, total
charging time, length of the loop of the boundary
cable.
Software
Shows the firmware version.
Displaying information
.
or and ac-
.
Robolinho 500 E/I | 1150 SE