Setting The Mowing Times; Edge Mowing With A Manual Start; Intouch - AL-KO 127406 Betriebsanleitung

Settings
1.
*"Entry Point"
2.
*"Point X1 at [020m]"
Select one digit in sequence with
and confirm each time with
3.
*"Point X2 at [075m]"
Select one digit in sequence with
confirm each time with
4. If necessary, specify further start points.
5. Return to the main menu.
7.6.3

Setting the mowing times

NOTE
There must be at least 30 min. between
programming the mowing times and the
mowing start. If not, the appliance only
starts at the next programmed mowing
time.
In the "Weekly Program" menu item, the days
of the week and time periods when the appliance
should mow are set. Adapt these settings to the
size of your garden if necessary. If unmown ar-
eas are still visible after approx. one week, in-
crease the mowing periods.
1.
*"Weekly Program"
■
*"All Days [X]": The appliance
mows every day at the set times. If "All
Days [ ]" is shown, the appliance only
mows on the set days of the week.
■
*"Monday [X]"...*"Sunday
[X]": The appliance mows for the set
time periods on the set day of the week.
If "Monday [ ]" is shown, for example,
the appliance does not mow on the re-
spective day.
■
"Change"
day [X] or deactivate it [ ], and set the
time periods, type of mowing and the
start points.
457296_b
to
.
and
.
: Activate the respective
2. Make the settings for every day or the re-
spective day:
■
For example, *"[M] 07:00-10:00
[?]": Normal mowing [M] from 07:00 –
10:00 am with automatically changing
start point 0 – 9 [?].
■
For example, *"[R] 16:00-18:00
[1]": The appliance starts with edge
mowing [R] at 4 pm and moves along
the entire boundary cable. The area
mowing then begins at start point 1 [1].
At 6 pm or as soon as the rechargeable
battery is discharged, the appliance
moves back to the base station.
■
"Change"
setting.
■
"Continue"
setting and continue to the next setting.
3. "Save" : Save all changed settings of
the menu item.
7.7

Edge mowing with a manual start

For a manual start, the setting can be made here
that the appliance begins with edge mowing.
Carrying out the edge mowing at the pro-
grammed mowing time periods: see chapter 7.6.3
"Setting the mowing times", page 61.
1.
*"Margin mowing"
2.
*"at manual start"
7.8

inTOUCH

An existing connection to a gateway can be dis-
connected. This means the appliance is ready to
establish a new connection for 30 minutes.
NOTE
To establish a connection later, the con-
nection must first be disconnected
again, even if the appliance was not pre-
viously connected with a gateway.
1.
*"inTOUCH"
2. "Reset connection"
Appliance reports: "Done".
3. Confirm with
: Change the selected
: Confirm the changes
and return to the menu.
61