Cancelling Mowing; Mowing The Secondary Area (01/Nf); Settings; Calling Up The Setting - General - AL-KO Robolinho series Betriebsanleitung

GB
7.5 "Edge mowing with a manual start",
page 51.
2. Start the appliance manually with
6.2

Cancelling mowing

■
Press on the appliance.
The appliance moves automatically into the
base station. It deletes the mowing plan of
the current day and starts again the next day
for the set time.
■
Press on the appliance.
The mowing is interrupted for half an hour.
■
Press on the appliance.
The appliance is switched off.
NOTE
In dangerous situations, the appliance
can be stopped with the STOP but-
ton (08/2).
6.3

Mowing the secondary area (01/NF)

1. Lift the appliance and place in the secondary
area by hand.
2. Switch on the appliance with
3. Call up the main menu with

* Settings

4. or
* Sub zone mowing
5. or
6. Select the mowing time with
7. Start the appliance manually with
Depending on the setting: The appliance mows
for the set time period and then switches off or
mows until the rechargeable battery is flat.
After mowing the secondary area, place the ap-
pliance in the base station again by hand.
7 SETTINGS
7.1 Calling up the setting – General
1. Call up the main menu with
Note: The asterisk * in front of the menu item
indicates that it has just been selected.
* Settings
2. or
3. Select the required menu item with
and accept with
50
.
.
.
or .
.
.
or
.
4. Make the settings.
Note: The menu items are described in the
following sections.
5. Return to the main menu with
NOTE
Further menu items: see chapter 5.2
"Making the basic settings", page 48.
7.2

Activating/deactivating the button tones

* Key clicks
1. or
2. Activating/deactivating the button tones:
■
Activate
or
Activate the button tones.
■
Deactivate
or
Deactivate the button tones.
7.3

Setting the mowing program

7.3.1 Setting the mowing program – General
1. Call up the main menu with
* Programs
2. or
3. Select the menu item with
cept with .
4. Carry out the settings.
Note: The menu items are described in the
following sections.
7.3.2

Setting the start points

Teaching-in start points
1. Place the appliance in the base station.
2. Switch on the appliance with
3. Call up the main menu with
* Programs
4. or
* Entry Point
5. or
* Interactive teach
6. or
* Start interactive entry
7. or
point teaching
■
Start
or
moves along the boundary cable.
■
Set
or
has reached the required start point. The
start point is stored.
.
:
:
.
or and ac-
.
.
:
. The appliance
when the appliance
Robolinho 500 E/I | 1150 SE
Settings