Setting The Cutting Height; Carrying Out An Automatic Calibration Movement; Operation; Starting The Appliance Manually - AL-KO Robolinho series Betriebsanleitung

Operation

one digit in sequence with
spectively confirm with
7. In the Enter time > HH:MM menu, set the
current time (format: HH:MM). To do so, se-
lect one digit in sequence with
respectively confirm with
The basic settings have been completed. The
Not calibrated Press Start key status
is displayed.
5.3

Setting the cutting height

The cutting height can be manually adjusted con-
tinuously between 25 – 55 mm.
NOTE
A cutting height of 55 mm is recom-
mended for the calibration movement
(see see chapter 5.4 "Carrying out an
automatic calibration movement",
page 49) and for teaching the starting
points (see see chapter 7.3.2 "Setting
the start points", page 50).
1. Open the cover (10/1).
2. Set the cutting height (the current cutting
height is displayed in the window (10/3) in
millimetres):
■
Increase the cutting height (i.e. lawn
height): Turn the rotary knob (10/2) clock-
wise (10/+).
■
Decrease the cutting height (i.e. lawn
height): Turn the rotary knob (10/2) anti-
clockwise (10/–).
3. Close the cover.
5.4 Carrying out an automatic calibration
movement
NOTE
Perform the calibration movement (see
see chapter 5.4 "Carrying out an auto-
matic calibration movement", page 49)
or teaching-in of the starting points (see
see chapter 7.3.2 "Setting the start
points", page 50) before commission-
ing.
495053_a
or and re-
.
or and
.
Place the appliance at the starting position
(09)
1. Place the appliance at the starting position in-
side the mowing area:
■
At least 1 m left and 1 m in front of the
base station
■
Aligned with the front side to the bound-
ary cable
Starting the calibration movement
1. Check that there are no obstacles in the ex-
pected movement area of the appliance. The
appliance must be able to move over the
boundary cable with both front wheels. Re-
move any obstacles if necessary.
2. Start the appliance with
shown on the display:
■
! Caution ! Starting Motors
■
Calibration , Phase [1]
During the calibration movement
To determine the signal strength inside the
boundary cable, the appliance first moves twice
straight beyond the boundary cable and then into
the base station and comes to a stop there.
■
The Calibration completed message is
shown on the display.
■
The rechargeable battery is being charged.
NOTE
The appliance must come to a stop
when it moves into the base station. If
the appliance does not touch the con-
tacts when it moves into the base sta-
tion, it moves further along the boundary
cable. If the appliance moves through
the base station, the calibration proce-
dure has failed. In this case, the base
station must be better aligned and the
calibration procedure repeated.
After the calibration movement
The preset current mowing duration is displayed.
For all further settings, refer to see chapter 7
"Settings", page 50.
6 OPERATION
6.1

Starting the appliance manually

1. Switch on the appliance with
For unscheduled edge mowing: see chapter
. The following is
.
49