Starting And Stopping The Motor (07); Starting And Stopping The Wheel Drive (08); Mowing With Grass Collector (09, 10) - AL-KO Solo 4757 Li SP Betriebsanleitung

Operation
1. Make sure that the appliance switched off
and the mower mechanism has come to a
stop.
2. Push the level (06/1) away from the appli-
ance (03/A) and hold, then shift to the re-
quired level (06/2) (03/B).
3. Let the lever (06/1) engage at the required
level.
6.3

Starting and stopping the motor (07)

Only start he appliance on level ground and not
in long grass. The ground must be free of foreign
bodies such as stones. Do not lift or tilt the appli-
ance for starting.
Starting the engine
1. Switch on the appliance: Insert the safety key
and turn to I.
2. Press the safety button (07/1) and hold (07/
A).
3. Pull the motor switch bracket (07/2) towards
the handlebar (07/3) (07/B). The motor and
mower mechanism are started.
4. Release the safety button (07/1) and hold the
motor switch bracket (07/2).
NOTE
The motor switch bracket does not lock in
place. Hold it tight against the handlebar
during the entire working period.
Stopping the motor
1. Release the motor switch bracket (07/2). It
automatically returns to the initial position
(07/C).
2. Wait for the mower mechanism to come to a
standstill.
3. Switch off the appliance: Turn the safety key
to 0 and remove it.
CAUTION!
Danger of cutting injuries
Danger of lacerations when reaching into
the running mower mechanism.
■
Wait until the mower mechanism has
stopped.
■
Before maintenance, care and clean-
ing work: Switch off the appliance
and remove the safety key.
456877_b
6.4 Starting and stopping the wheel drive
(08)
NOTE
The wheel drive can only be started with
the motor running.
Switching on the wheel drive
1. Switch on the appliance and start the motor.
2. Press the gear engagement bar (08/1)
against the handlebar (08/2) and hold (08/A).
The gear engagement does not lock in place.
Stopping the wheel drive
1. Release the gear engagement (08/1) (08/B).
It automatically returns to its initial position.
6.5

Mowing with grass collector (09, 10)

The appliance can be operated with and without
grass collector.
Attaching the grass collector
1. Make sure that the appliance switched off
and the mower mechanism has come to a
stop.
2. Raise the impact flap (09/1) (09/A).
3. Hook the grass collector (09/2) into the hold-
ers (09/B).
4. Release the impact flap (09/1).
Removing and emptying the grass collector
CAUTION!
Danger of cutting injuries
Danger of lacerations when reaching into
the running mower mechanism.
■
Only remove the grass collector
when the mower mechanism has
stopped.
1. Switch off the appliance: Turn the safety key
to 0 and remove it.
2. Raise the impact flap (09/1).
3. Lift the grass collector (09/2) out of the hold-
ers and take off to the rear.
4. Empty the grass collector.
5. Clean the exhaust holes of the fill level indic-
ator (10/1).
6. Attach the grass collector (see above).
27