Operation; Setting The Cutting Height For The 3.29 Li (06); Setting The Cutting Height For The Moweo 3.85 Li (07); Starting And Stopping The Motor (09 Or 10) - AL-KO Moweo 3.85 Li Betriebsanleitung

Operation

6 OPERATION
WARNING!
Danger if assembly is not carried out
completely!
Operation of an incompletely assembled
appliance can result in serious injury.
■
Only operate the appliance when it
is fully assembled.
■
Do not insert the battery into the ap-
pliance until it is fully assembled.
■
Check that all safety and protective
devices are in place and functioning
correctly before switching on.
6.1 Setting the cutting height for the 3.29 Li
(06)
CAUTION!
Danger of lacerations
Danger of lacerations when reaching in-
to the running mower mechanism.
■
Only adjust the cutting height when
the motor is switched off and the
mower mechanism is stationary.
1. Press the release lever (06/1) outwards
slightly (06/a) and hold it.
■
For shorter grass, push the lever towards
the front wheel (06/a), minimum level 1:
approx. 2.5 cm
■
For longer grass, push the lever towards
the rear wheel (06/b), maximum level 5:
approx. 6.5 cm
2. Release the lever until it engages at the re-
quired level.
6.2 Setting the cutting height for the Moweo
3.85 Li (07)
CAUTION!
Danger of lacerations
Danger of lacerations when reaching in-
to the running mower mechanism.
■
Only adjust the cutting height when
the motor is switched off and the
mower mechanism is stationary.
1. For shorter grass, push the lever towards the
front wheel (07/a), minimum level 1: approx.
2.5 cm
441600_d
2. For longer grass, push the lever towards the
rear wheel (07/b), maximum level 6: approx.
7.5 cm
6.3 Starting and stopping the motor (09 or
10)
IMPORTANT!
Danger of damage to the appliance
The engine and blade system can be
damaged by consecutively switching on
and off briefly several times.
■
Only switch the engine on when the
mower mechanism has stopped.
Starting the engine
1. Press the start button (09/1 or 10/1) and keep
it pressed (09/a or 10/a).
2. Pull the safety handle (09/2) or operator pres-
ence control (10/2) towards the handlebar
(09/3 or 10/3) (09/b or 10/b). Start the engine
and mower mechanism.
3. Release the start button (09/1 or 10/1) while
holding the safety handle (09/2) or operator
presence control (10/2).
NOTE
The safety handle/operator presence
control does not lock in place. Hold it
tight against the handlebar during the
entire working period.
Stopping the engine
1. Release the safety handle (09/2) or safety
bar (10/2). It automatically moves to its initial
position.
The engine stops immediately. The mower mech-
anism keeps running until it stops.
CAUTION!
Danger of lacerations
There is a danger of lacerations when
reaching into the mower mechanism
while it is running on.
■
Wait until the mower mechanism
has stopped.
6.4

Mowing with grass collector (08)

The appliance can be operated with and without
grass collector.
Attaching the grass collector
1. Stop the motor (see chapter 6.3 "Starting and
stopping the motor (09 or 10)", page 33).
33