Introduction; Device Description; Scope Of Delivery; Intended Use - Scheppach MTP870H Originalbetriebsanleitung

1. Introduction

Manufaturer:
scheppach
Fabrikation von Holzbearbeitungsmaschinen GmbH
Günzburger Straße 69
D-89335 Ichenhausen
Dear customer,
We hope your new tool brings you much enjoyment
and success.
Note:
According to the applicable product liability laws, the
manufacturer of the device does not assume liability
for damages to the product or damages caused by
the
product that occurs due to:
• Improper handling,
• Non-compliance of the operating instructions,
• Repairs by third parties, not by authorized service
technicians,
• Installation and replacement of non-original spare
parts,
• Application other than specified,
We recommend:
Read through the complete text in the operating
instructions before installing and commissioning the
device. The operating instructions are intended to
help the user to become familiar with the machine
and take advantage of its application possibilities
in accordance with the recommendations. The
operating instructions contain important information
on how to operate the machine safely, profession-
ally and economically, how to avoid danger, costly
repairs, reduce downtimes and how to increase reli-
ability and service life of the machine.
In addition to the safety regulations in the operating
instructions, you have to meet the applicable regula-
tions that apply for the operation of the machine in
your country.
Keep the operating instructions package with the
machine at all times and store it in a plastic cover to
protect it from dirt and moisture. Read the instruc-
tion manual each time before operating the machine
and carefully follow its information. The machine can
only be operated by persons who were instructed
concerning the operation of the machine and who
are informed about the associated dangers. The
minimum age requirement must be complied with.
2. Device description (Fig. 1+2)
1. Housing with engine and transmission
2. Reverse starter
3. Fuel tank
4. Throttle lever/choke/stop
5. Handlebar with crossbar (pre-assembled)
6. Clutch lever with clutch lock
7. Fuel valve
8. Air filter
9. Blade guard
10. Side guard
11. Blade extension
12. Blade
13. Transmission
14. Spark plug connector
15. Oil filling nozzle
16. Wheels
17. Depth regulator
3. Scope of delivery (Fig. 3)
A. Housing with engine and transmission
B. Bag with assembly material
C. Wheels
D. Handlebar mounting (top)
E. Blade extension 2x
F. Blade guard extension 2x
G. Depth regulator mounting
H. Depth regulator with wheel mounting
I. Handlebar mounting (bottom)
J. Engine handbook
K. Operating manual
• Open the packaging and remove the device care-
fully.
• Remove the packaging material as well as the
packaging and transport bracing (if available).
• Check that the delivery is complete.
• Check the device and accessory parts for trans-
port damage. When complaints the dealer must be
informed immediately. Subsequent complaints will
not be accepted.
• If possible, store the packaging until the warranty
period has expired.
• Read the operating instructions to make yourself
familiar with the device prior to using it.
• Only use original parts for accessories as well as
for wearing and spare parts. Spare parts are avail-
able from your specialized dealer.
• Specify our part numbers as well as the type and
year of construction of the device in your orders.
m ATTENTION!
The device and packaging materials are not
toys! Children must not be allowed to play with
plastic bags, film and small parts! There is a risk
of swallowing and suffocation!

4. Intended use

The machine is designed for digging over beds and
fields. Be sure to observe the restrictions in the ad-
ditional safety instructions.
The equipment is allowed to be used only for its
prescribed purpose. Any other use is deemed to be
a case of misuse. The user/operator and not the
manufacturer will be liable for any damage or inju-
ries of any kind resulting from such misuse.