Operation; Switching On And Off; Sanding; Cleaning - Parkside PTSG 140 B2 Originalbetriebsanleitung

G B I E
Removing external dust
extraction:
3. Gently turn and pull on the angle adap-
ter (14) to remove it.
It can be removed when the arrow on the
angle adapter (14) and the marking on
the device housing are exactly aligned.
An additional adapter (15) with a
larger diameter is provided with the
device and this can, if required, be
attached to the angle adapter (14).
If necessary, you can connect the
suction hose of a vacuum cleaner
directly onto the angle adapter.

Operation

Before initial operation, perform a trial run
at top speed without a load for at least 1
minute. Remain outside the hazard area
while doing so.

Switching on and off

Make sure that the power supply
voltage matches the voltage rating
indicated on the device's type plate.
Connect the machine to the power
supply.
1. Select the desired speed using the
speed regulator (2).
Switching on:
2. Press the power switch "I" (3), the de-
vice starts.
Switching off:
3. Press the off switch „O" (3), the device
turns off.
4. Next, remove the mains plug (5) from
the wall socket.
2 4
After switching on the device, wait until the
device has reached its max. speed. Only
then may you commence sanding.

Sanding

The arrow
( 1) indicates the direction of rotation of
A B C D
the disc sanding device.
K L M N
The sanding speed can be regulated using
U V W X
the speed regulator (
Mounting horizontally (
• Place the workpiece on the sanding
table (11) and slowly bring it to the
desired angle towards the left half of
the sanding disc (
Mounting vertically (
• Slowly bring the workpiece to the desired
angle towards the sanding disc (

Cleaning

Pull the mains plug before any ad-
justments, maintenance or repair.
Do not use any cleaning agents or
solvents. Chemical substances can etch
the plastic parts of the device. Never
clean the device under running water.
Have any work on the device
that is not described in this ins-
truction guide performed by a
professional. Only use original
parts. Allow the device to cool
off before any maintenance
or cleaning is undertaken.
There is a risk of burning!
• Thoroughly clean the device after every
use.
above the sanding disc
E F G
O P Q
Y Z
2).
A B C
K L M
):

U V W
1).
A B C
K L M
):

U V W
A
K
U
H I J
R S T
D E F G
N O P Q
X Y Z
D E F G
N O P Q
X Y Z
1).
B C D
L M N
V W X