Cleaning And Maintenance; Cleaning; General Maintenance - Parkside PDOS 200 B2 Originalbetriebsanleitung

G B MT
1. Undo the fixing screws (
remove the left-hand and right-
hand grinding disc cover (
2. Unscrew the grinding disc nuts
(10a) by counter-holding the nut
on the opposite grinding disc with
a spanner (size 19 mm).
Unscrewing the left-hand nut (left-
hand thread):
turn clockwise.
Unscrewing the right-hand nut
(right-hand thread):
turn anticlockwise.
3. Remove the clamping flange (10b)
and the grinding disc (10).
4. Set up the new grinding disc (10)
with the intermediate shims (10c)
made of cardboard and the clam-
ping flange (10b) and manually
screw the grinding disc nut (10a)
on.
Screwing the left-hand nut (left-
hand thread) on:
turn anticlockwise.
Screwing the right-hand nut (right-
hand thread) on:
turn clockwise.
5. Screw the left hand and right
hand grinding disc covers (8) on.
6. Adjust the spark protection (
and the workpiece support (
11) - the distance to the grinding
disc (10) is max. 2 mm (see „As-
sembly")
The grinding disc nut must not be
screwed too tightly in order to
avoid a breaking of the grinding
disc and nut.
7. Test run:
Before starting work and after each
change of grinding disc, carry out a
test run of at least 60 seconds with no
4 4
7) and load. Switch off the equipment immedi-
ately if the disc runs lumpy, substantial
8). vibrations occur, or abnormal noises
are generated.
Cleaning and
maintenance
Disconnect the plug before adjust-
ment, maintenance or repair.
Have any work not described
in these instructions carried
out by a specialist workshop.
Use only original components.
Allow the equipment to cool
before carrying out any main-
tenance and cleaning work.
There is a risk of burns.

Cleaning

Do not use cleaning agents or sol-
vents. Chemical substances may
attack plastic parts of the equipment.
Never clean the equipment under
running water.
• Clean the equipment thoroughly after
1) each use.
• Clean the surface of the equipment
with a brush or cloth.

General maintenance

Before each use, check the equipment
for obvious defects such as loose, worn
or damaged components and check that
screws or other parts are sitting correctly.
In particular, check the grinding disc (
10). Replace damaged parts.