Electrical System - buster Magnum Pro Betriebsanleitung

Keep the following in mind:
Never obstruct access to safety equipment, such as the fire extinguisher
•
or the main switch of the electrical system. If the storage space in the bow
of the boat (where the fire extinguisher is located) is locked, remember to
unlock it whenever you use the boat.
• Never block any ventilation holes made in the boat, as these are intended
to discharge fuel gases.
Never alter the boat's electrical or fuel systems or allow an unqualified
•
person to modify any of the boat's systems.
• Never attempt to switch fuel tanks by removing the fuel pipe from the
detachable fuel tank when the motor is in use.
Never fill the fuel tank or handle fuel when the engine is running.
•
Never smoke or use a naked flame when handling fuel.
•

5.8 Electrical system

The locations of the boat's electrical equipment are shown in Appendix 1,
Figure 3.
The wiring diagrams of the electrical system are shown in Appendix 4.
The main switch on the Buster XSr, S, and Scc is located on the wall of the rear
bench on the left side. The main switch on the Buster M, Mcc, L, Lx, L Pro, X,
XL, XL Pro, XLe Convertible, XLe, XXL, Magnum, Magnum Pro, SuperMagnum,
and Magnum M5 is located inside the rear bench on the left side of the boat on
the side of the battery enclosure. On the Buster Cabin, the main switch is in the
back-right corner of the cabin. On the Buster Le, the main switch is inside the left
bench, which can be accessed from the floor area. The circuit is live when the key is
turned clockwise. When the key is in the vertical position, the boat's entire electrical
system is switched off and the key can be removed from the switch. Depending
on the model, the switch may also have the symbols 0=off and I=on. However, the
automatic bilge pump and the radio's memory circuit remain operational whenever
the battery is attached to the electrical system, regardless of the position of the
main switch.
The fuses on the Buster S, Scc, XLe Convertible, XLe, Cabin, and Magnum Pro are
located in the immediate vicinity of the battery enclosure, on a separate fuse board.
The fuses on the Buster M, Mcc, L, Lx, and L Pro are located on the side of the
battery enclosure. On the Buster X, XL, XL Pro, XXL, Magnum, Magnum M5, and
SuperMagnum, the main switch and the fuses for the bilge pump, the power outlet
in the left seat (Buster X only), and the radio's memory circuit are located on the
side of the battery enclosure. On these boats, the fuses for other circuits are located
on the switch panel in the seat. Buster boats use automatic circuit breakers that
enable the current to be switched back on following a circuit overload. If a button
has popped up, the current can be switched back on by pressing the button back
down. The main fuse and the fuse for the continuous power supply on the Buster
XLe and Le are next to the main switch. Both fuses are automatic circuit breakers.
The fuses for other circuits on the Buster XLe and Le are located on the switch
89 (98)