Changing Tools; 2-Speed Gearbox; Removing The Chuck; Using The Bit Adapter - Parkside PBSA 12 C2 Originalbetriebsanleitung

Changing tools

Your cordless screwdriver has a fully automatic
spindle lock .
When the motor is stopped, the power train locks
so that the quick-release chuck
by turning it . After you have attached the
desired tool and tightened it by turning the chuck
, you can continue working. The spindle lock is
automatically released when the motor starts
(ON/OFF switch pressed).

2-speed gearbox

CAUTION!
► Operate the speed selector
the appliance is at a standstill. Otherwise the
appliance can be damaged.
In first gear (speed selector
you can reach a speed of approx. 350 rpm and a
high torque. This setting is suitable for all screwing
jobs.
In second gear (speed selector
you can reach a speed of approx. 1300 rpm for
carrying out drilling work.

Removing the chuck

If you want to use the bit adapter
remove the quick-release chuck
Removing the chuck:
♦ Hold the quick-release chuck
front.
♦ Pull/push the chuck ring
the quick-release chuck
The quick-release chuck
can be removed towards the front.
PBSA 12 C2
can be opened
only when
in position: 1)
in position: 2)
, you must
.
firmly from the
in the direction of
10a
.
is now unlocked and
Attaching the quick-release chuck:
♦ To replace the quick-release chuck
chuck ring towards the quick-release chuck
10a
. Push the quick-release chuck
adapter . Let go of the chuck ring
the quick-release chuck
NOTE
► If the quick-release chuck
automatically click into place, turn the chuck
ring .
10a

Using the bit adapter

After removing the quick release chuck
use the bit adapter .
♦ Insert a suitable bit into the bit adapter
♦ Push the bit into the bit adapter
stop.
The guidance and the magnetic holder keep the
bit firmly in place.
♦ Pull the bit out of the bit adapter

Torque selection ring/drill setting

You can set the torque using the torque selection
ring .
♦ Select a low level for small screws or soft
materials.
♦ Select a high level for large screws, hard materi-
als or removing screws.
♦ Select the drill setting for drilling work by
adjusting the torque selection ring
position .
♦ Push the speed selector
work (position: 2).
, pull the
over the bit
to click
10a
into place.
does not
, you can
.
as far as the
.
to the
forward for drilling
GB │ IE │
19 ■