Herunterladen Inhalt Inhalt Diese Seite drucken

Using The "Customize" Function - Kathrein MSK 115/S2 Betriebsanleitung

Inhaltsverzeichnis

Werbung

Verfügbare Sprachen

Verfügbare Sprachen

USING THE "CUSTOMIZE" FUNCTION

Searching
After the local oscillator has been set, the desired carrier frequency can be selected.
Note: The selected local oscillator determines the available frequency range.
Carrier
Searching
Searching
Searching
18
OPERATING MENU
Navigate to the "Custom" menu and select the custom transponder
to be changed.
You can then open the "Customize" menu and modify this
transponder as required.
First use the
There are various local oscillators available, some of which also
have a 22 kHz tone available. The local oscillators are listed in
the table below.
When you have made your selection, press the
the oscillator frequency.
(The menu shown here is just for explanation; it is not visible in
this form).
To set the desired frequency, use the
the highlighted number. Pressing the
the next number. When the required frequency has been reached,
press the
button to switch to the "Symbol rate" screen. Take
care not to select values outside the valid range (e.g. 20700 MHz
in Ku band mode).
The symbol rate is set in the same way as setting the frequency
for the desired signal. Use the
desired number and use the
value. Symbol rates can be set to values between "01000" and
"45000". When the desired symbol rate has been reached, press
the
button to switch to the "FEC" screen.
This screen allows you to select the desired FEC. If
you do not know the FEC, select "Unknown". The MSK
115/S2 will test all FEC settings during the search
after "Enter carrier". The available FECs are listed in
the table on the right. Press the
the "LNB Voltage" screen.
and
buttons to select your local oscillator.
and
and
button to switch to
button to set
and
buttons to change
or
button switches to
buttons to highlight the
buttons to change the

Quicklinks ausblenden:

Werbung

Kapitel

Inhaltsverzeichnis
loading

Inhaltsverzeichnis