Logging Measurement Results; Log As 000X; Log All; Lnb/Cable Test - Kathrein MSK 115/S2 Betriebsanleitung

LOGGING MEASUREMENT RESULTS

Before you use the Log function, you must fi rst register the selected satellite. Make sure that the reception
levels are as good as possible. You can download the logging software required to read out the measuring
instrument's saved data entries from Kathrein's download page on the Web. The software also allows you
to export the data as a CSV fi le.

LOG AS 000X

Press the -button to select the function „Log as 000x". The measured value of the latest measurement
(level and confi guration of the selected transponder) will be saved and numbered under this item; the sto-
rage number will increase by one every time you save. Make a note of the the storage number on a slip of
paper prior to saving; you will need it later on when the measuring instrument log data is evaluated.

LOG ALL

Press the -button to select the function „Log all". The level and settings of the selected satellite (e.g. all
levels) will be saved and numbered under this item; the storage number will increase by one every time you
save. Make a note of the the storage number on a slip of paper prior to saving; you will need it later on when
the measuring instrument log data is evaluated.

LNB/CABLE TEST

The "LNB/Cable Test" is a quick function for searching for possible faults; it can be used to indicate whether
any problems are present.
LNB/Cable
Please wait ...
Note: The functions listed above are intended only for display purposes.
LNB/Cable
LNB/Cable
20
OPERATING MENU
The test results appear after a few seconds as shown below.
Repeat
fault
Repeat