Data Transfer - Kathrein MSK 115/S2 Betriebsanleitung

The data transfer software referred to here is not supplied as standard with the measuring instrument!
It is available for download from ESC-Kathrein under "MSK115-S2 Firmware Load". After the USB
drivers have been installed, you can download the updated transponder list from the ESC Kathrein Download
website as an update for the MSK 115/S2. Go to www.esc-kathrein.de and follow the instructions listed below
to download new software onto your measuring instrument.
Disconnect the measuring instrument from the computer → Switch on → Ready for use.
Trouble-shooting to overcome fi le transfer problems.

DATA TRANSFER

1) Wait until the MSK 115/S2 displays "Program mode" (the display may
fl ash and the buzzer sound while communication is being established;
this does not indicate a fault).
Important: The software must be installed, without the use of german
Umlauts (ä=ae), in a common directory.
2) Make sure that the USB port has been activated.
Click on "Upgrade".
The upgrade menu will appear after a few seconds. Click the
„Upgrade" button to begin transmission.
3) When it is completed, a
window with the message
"Upgrade Complete!" will
appear. Click on "OK" and
close the program.
If the error message "Error - Ack not received"
is displayed, check that the USB connection
has been established correctly and that the
USB cable is not damaged.
23