Save And Exit - Kathrein MSK 115/S2 Betriebsanleitung

Searching
Searching
Pilots
Searching
Once all parameters have been set, it is possible to save a carrier separately from the pre-defi ned
selection.

Save and Exit

Searching
Discard
Searching
Note: The MSK 115/S2 is only compatible with DVB-QPSK-modulated carriers, as well as DVB-S2,
8PSK and ASTRA-DSL (ASTRA-2-Connect), and will not achieve locking on with other modulation
types. When using lower symbol rates (less than "04000"), the locking on process may take several
seconds. The alignment speed of your antenna must be signifi cantly slower.
Tip: Various frequently occurring carrier constellations can lead to a multiple lock-on. Carriers with an
FEC of 3/4 and a symbol rate of 27500 are likely to lock on to different satellites.
OPERATING MENU
The desired LNB voltage can be selected in this menu (18 Volt
for horizontal or 13 Volt for vertical). Press the
to the "IQ" screen.
Note: If you use a block LNB for a single cable installation,
13 Volt is typically chosen as the supply for this type
of LNB, since the polarisation is set manually. Look up
the precise requirements in the documentation for your
LNB.
Here the IQ can be switched between Standard (not swapped)
and Swapped. Sometimes the Swapped setting is necessary for
the IQ in order to achieve locking on. Mostly however it should
be set to Standard (not swapped). If you have been unable to
achieve locking on, use the Swapped setting.
When you have made the setting, use the
"Save and Exit" or "Discard" screens.
This function is only available in DVB-S2 mode. You can set
this function here depending on whether the satellite operator
transmits pilots or not. In the „Auto" setting, the MSK 115/S2
automatically identifi es the confi guration.
Pressing the button on this screen saves your own "Custom"
carrier. The screen now switches into search mode, in which you
can use your carrier settings to fi nd the desired service.
If you do not wish to save your settings, press the
bring up the "Discard" screen. If you wish to use your carrier
during a later installation, you can call it up again from the sub-
menu via the "Custom" option.
On this screen, press the
have set. The measuring instrument returns to search mode
for the satellite last selected before calling up "Custom" mode.
Alternatively, press the
options to select another carrier of your choice.
button to switch
button to open the
button to discard all the values you
button to scroll through the carrier
button to
19