Charging The Battery - Kathrein MSK 115/S2 Betriebsanleitung

The measuring instrument is NOT fully charged when delivered. Before fi rst use, the battery should be
charged once for 24 hours.
The battery pack can easily be changed. The power supply must be unplugged before the unit can be
opened. To replace the battery, remove the measuring instrument from its protective case, open the cover
on the underside of the instrument and undo the battery connections.
Insert and connect up the new battery. Refi t the cover and fully charge the instrument to ensure safe battery
operation.
The DC adapter supplied also allows the battery to be charged from a car battery.
If charging in the vehicle, only use the cable supplied. Other cables may damage the instrument and
lead to invalidation of the guarantee/warranty. The MSK 115/S2 can be left connected to the charging
source for an extended period in the "quick charging" state of charge. If the unit is to be charged for a
long period of time, it will switch to trickle charging; in this mode it is only charged very little so that the
unit's inner components do not suffer damage and so that the unit can remain plugged to the power
source with its accu pack for a prolonged period of time. Very little charge is delivered in this state,
meaning that the instrument can remain on charge for extended periods without damage to its internal
components or to the battery pack. When the battery is fully charged, the instrument will display "Fully
charged".
Note: Whilst it is being charged, the measuring instrument cannot be switched on.
The ambient temperature when the power supply is in use must be less than 40° C!
The mains cord must not be replaced with an inadequately rated one!

CHARGING THE BATTERY

Charging using the power supply unit and in-car charging cable
The bottom side of the bag features a small fl ap with hook-and-loop
fastener which protects the power supply and charging cable. Plug
the power supply unit or in-car charging cable into the socket, and
if using the in-car charging cable, plug the other end into the car
socket (cigarette lighter and standard 12-Volt outlet).
9