Kathrein MSK 115/S2 Betriebsanleitung Seite 41

Customize
For more
Orientation
Log as 00000
Log All
LNB Drift
For more
Log as 00000
Log All
LNB Drift
LNB/Cable Test
For more
Log as 00000
Log All
LNB Drift
LNB/Cable Test
For more
Log as 00000
Log All
LNB Drift
LNB/Cable Test
For more
OPERATING MENU
Pressing „Custom" calls up the list of custom carriers. After
selecting this list, you can select a previously saved carrier.
The "Log as 000xx function allows the most recent measurement
result to be saved under a sequential number. The additional
"Kathrein LOG reader" software allows these results to be
displayed in a table on the PC.
In "Log All", all transponders for the confi gured satellite are
measured and saved.
The "LNB/Cable Test" function provides a test current to check
the cable resistance to the LNB. If this is too low or the cable is
open circuit, the message: "LNB/Cable fault" appears.
A frequency deviation in the implementation of an LNB is
displayed here. If the deviation is more than 3 MHz, the display
will read: "LNB Problem"
13