Kathrein MSK 115/S2 Betriebsanleitung Seite 40

For more
Constellation
For more
C
For more
Customize
For more
Orientation
Log as 00000
Log All
For more
12
OPERATING MENU
To call up the sub-menu on the display, press the
Use the cursor buttons to select from the various options. The
measuring instrument can be switched off at any time. To do so,
press and hold down the
also use the button to switch off the measuring instrument.
The DiSEqC LNB function allows you to issue a DiSEqC
TM
switching command. There are 16 SAT levels selectable for
this. As soon as a command has been selected, the instrument
automatically reverts to the search screen. To exit this screen
without triggering the command, you can scroll back and
highlight "Exit". A comprehensive explanation of the spectrum
and constellation menu can be found on pages 16 and 17 in this
operating manual.
The "Customize" mode is a function that allows you to defi ne
your own carrier on to which you wish to lock. This can be very
useful if you wish to optimise a specifi c service after the satellite
has been located. This function can also be used for a "single
cable system". This selection can also be saved separately from
your pre-defi ned selection. A comprehensive explanation of the
"Enter carrier" mode can be found on page 18 onwards.
DVB-S2: Here you can switch between DVB-S2 and DVB-S1
operation modes
DSL: Here you you can select the operation mode for
measurement of data transponders
The "LNB 21V" function is intended for future extended functions
in a single cable system.
This setting only works in the "Custom" - "Carrier" menu.
For the satellites you have set up, you can query the correct
position in your location for exact alignment. To do so, follow the
logical menu navigation to set your location. The instrument will
then display the data for the precise alignment of the antenna.
button. If "Exit" is highlighted, you can
button.
TM