Inhaltsverzeichnis
Werbung
Night mode
The night mode will dim the display and run quietly, making it ideal for use while sleeping.
When night mode is enabled (indicated by an illuminated half
moon symbol in the bottom right corner of the display), the display
will dim and after 5 seconds will fade to off. The half moon symbol
remains illuminated.
If the appliance is not in auto mode, the airflow speed will reduce to level 4. When night mode is activated, if it is already below level 4, it will
remain the same. This can be manually changed if desired. The display will illuminate briefly, then fade as before. If in auto mode the airflow
speed will be reduced automatically.
Oscillation
Oscillation control
To start the appliance
oscillating, press the oscillation
control button. To stop the
appliance oscillating, press
it again. The appliance will
not oscillate when the control
buttons are pressed.
Diffused and focused modes
Diffused mode
Press the wide angle button
to change from a personal
directed airflow to wider
projection of air flow.
Heating and cooling modes
work in this mode.
54
5 secs
Airflow speed control
Airflow speed control
To change the airflow speed
press the airflow control button.
The digital display will show
the new fan speed. If in heater
mode after 2.5 seconds it will
change back to displaying the
target temperature.
Focused mode
Press the narrow angle button to
change from a wider projection
of airflow to a personal directed
airflow.
Heating and cooling modes work
in this mode.
Sleep timer
The sleep timer will
turn your appliance
off once the time
set has passed.
To set the sleep timer, select the desired time. When time reaches
zero, the appliance will go into standby mode. To cancel,
increase the time until two dashes appear.
Clearing blockages
Ensure the appliance is unplugged. If the appliance has been in use, leave for 1 to 2 hours in order to allow the appliance to cool down
completely. Look for blockages in the air inlet holes and in the small aperture inside the air loop amplifier. Use a soft brush to remove debris.
Cleaning
Unplug from the mains electricity supply. If the appliance has been in use, leave for 1 to
2 hours before cleaning to allow the appliance to cool completely. Dust may accumulate
on the surface of the machine. Wipe dust from the loop, filter unit and other parts with a
dry or damp cloth when dust accumulates. Do not use detergents or polishes.
Tilt function
Carefully hold the base and the main body. Tilt the amplifier
forward or backward for the required airflow angle.
CAUTION: hot when in use
This appliance is hot when in use and for a
short period after use. Do not let bare skin
touch hot surfaces. If children are present,
consider positioning the appliance out of
their reach.
55
Werbung
Inhaltsverzeichnis
