Inhaltsverzeichnis
Werbung
Heating and cooling modes
Appliance is in cooling mode
Press the blue cooling mode button to enter cooling mode.
The power button light will change from red to blue to indicate that
you have entered cooling mode. To adjust the airflow speed use the
airflow control button or use auto mode for automatic control.
Appliance is in heating mode
Press the red thermostat control button until the digital display shows the target room temperature. The power button light will change from blue
to red to indicate that you have entered heating mode. The heating symbol will be red while heating and will change to white when the target
room temperature has been reached. Once the target room temperature has been reached, the appliance will stop heating the air. If the room
temperature falls below the target temperature, the appliance will start to heat again. The red circle surrounding the power button remains on
when the product is in heater mode. To adjust the airflow speed use the airflow control button or use auto mode for automatic control.
Room heating to 23°C
On first use, the appliance will default to a temperature 3°C higher
than the detected room temperature. Thereafter, the appliance will
remember the last target temperature set.
Each time the heating mode is selected, it conducts a short
calibration cycle. Airflow will be automatically controlled during
this cycle. Once the calibration cycle is complete, it will revert to the
selected airflow speed.
52
Room heated to 23°C or above
Auto mode
Selecting Auto mode adjusts the airflow according to the air quality in the room.
When auto mode is enabled (indicated by an A symbol in the bottom left corner of the display), the on-board sensors will intelligently adjust the
speed of the appliance according to the air quality.
Auto mode behaviour differs slightly between cooling and heating modes.
Appliance is in auto cooling mode
Air quality below target
Air quality improving
If the air is clean the A symbol will turn green and the numerical display will switch off. If the air quality worsens the A symbol will turn white and
the appliance will automatically restart purifying the room. While purifying the numerical display will show the airflow speed.
Appliance is in auto heating mode
• Air quality below target
• Air quality below target
• Below target room
• Target room
temperature
temperature met
• Air quality target met
• Air quality target met
• Below target room
• Target room
temperature
temperature met
When auto mode is used while in heating mode, the appliance is both purifying and heating the air. The appliance will display the target room
temperature, not the fan airflow. Once the target room temperature has been reached, the appliance will stop heating the air. If the air quality
target has not been met, the fan will continue to run in order to keep purifying the air. If the room temperature falls below the target temperature,
the appliance will start to heat again.
For additional control the Dyson Link app can be used to further adjust the sensitivity of the appliance remotely.
A period of 6 days is required after the machine is first used for the sensor to calibrate.
During this period the machine may be more sensitive to VOCs (such as odours) than normal.
Air quality target met
53
Werbung
Inhaltsverzeichnis
