Siko AP05 Originalmontageanleitung Seite 31

AP05
Commissioning
LED-Bus
In the basic state (factory setting), the LED display has the following
meaning.
Bus connection Color
RS485
CAN
For additional LED states and their meanings refer to the User manual.
Configuration
The required parameters are set in the configuration mode. On the 1st
line of the display, the parameter will be shown and on the 2nd line the
respective value will be displayed.
Press
entering a multi-digit value.
The
numbers.
By pressing the
atilely. If no key is pressed, the configuration mode will be exited after
~30 s without saving the latest value displayed, i. e. the original value will
be maintained.
For a detailed description of the configuration parameters refer to the
User manual.
Calibration
Two steps are required for executing calibration:
1. Write the calibration value in the configuration mode or via the bus
2. Execute calibration (reset) (see chapter 5: Display and control keys
Since the measuring system is an absolute system, calibration is necessary
only once with commissioning.
AP05 · Date 25.09.2018 · Art. No. 88847 · Mod. status 316/18
2
yellow on
green
red
red/
green
key for changing actual value and / or the blinking digit when
key serves for switching to the next digit in case of multi-digit
key, the set value is acknowledged and saved non-vol-
interface (see User manual)
=> Position value = current measured value + calibration value + off-
set value
and Additional)
=> Position value = 0 + calibration value + offset value
State Description
bus operation active
off no bus operation
blinks NMT-state = Pre-Operational
on NMT-state = Operational
on CAN Error = Bus off
off CAN Error = no error
flickering CAN-Ongoing initialization
alternately
English 31