Identification; Installation - Siko AP05 Originalmontageanleitung

AP05

Identification

External magnetic fields
CAUTION
Failures and data loss occur if strong magnetic fields influence the internal
measuring system.
` Protect the position indicator from impact by external magnets.
3 Identification
Please check the particular type of unit and type number from the identifi-
cation plate. Type number and the corresponding version are indicated in
the delivery documentation.
e. g.

4 Installation

Position indicator failure/damage to the connector insert
WARNING
The connector insert in the device will be damaged if the torque applied to
the mating connector is too high.
` Tighten the mating connector using the torque-limiting wrench of
` Using a torque wrench tighten the mating connector(see chapter 8.1,
` Do not transmit torque/forces into the device via the housing of the
Position indicator failure/mechanical stress on the mating connector
WARNING
Excessive external force impacting on the mating connector will damage
components of the position indicator and/or the mating connector.
` Protect the mating connector from impact of external forces.
` In areas where the impact of forces caused by the operating personnel
AP05 · Date 25.09.2018 · Art. No. 88847 · Mod. status 316/18
-
AP05 0023
variant number
type of unit
the relevant connector vendor. Pay attention to the tightening torque
specified by the manufacturer.
8.2 and 8.3). Manufacturer's recommendation of a suitable torque can
be obtained on request. Tightening torque: 0.4 Nm
mating connector or cable. Tighten only the securing nut of the mat-
ing connector.
or dropping objects cannot be excluded attach an effective support of
the mating connectors against the machine body.
English 23