Process Conditions; Installation; Mounting Location - Siemens pointek CLS 200 Kurzanleitung

Process connections
Compact (std.) configuration
Sanitary configuration
Cable configuration

Process Conditions

• dielectric constant (εr)
1
• temperature :
- std. configuration
- std. (with extension)
- slide coupling
• pressure (vessel):
- std. configuration
- cable configuration
- slide coupling

Installation

Notes:
• Installation shall only be performed by qualified personnel and in accordance with local
governing regulations.
• This product is susceptible to electrostatic shock. Follow proper grounding procedures.
• The housing may only be opened for maintenance, local operation, or electrical
installation.
• Before installing the instrument, verify that the environment complies with any restrictions
specified on the device nameplate.

Mounting Location

Notes:
• Keep the sensor at least 50 mm (2") away from any nozzle or tank wall.
• If multiple units are used, allow at least 100 mm (4") between them, to prevent interference
(mount diagonally if space is restricted).
• Do: provide a sun shield to protect the transmitter from direct heat radiation.
• Do not: exceed the permissible ambient temperature limits (see page 5 for the analog
model, and page 10 for the digital model).
• Do not: mount Pointek CLS 200 in locations subject to strong vibrations (if it can be
avoided).
1.
At process connection.
7ML19985QE81 Pointek CLS 200 (analog/digital) – QUICK START MANUAL
¾", 1", or 1 ½" BSPT or NPT; 1 1/4" NPT only
1", 1 ½", and 2" 3A compliant tri-clamp
¾", 1", or 1 ½" BSPT or NPT; 1 1/4" NPT only
1.5 minimum
o
–40 to 85 C (–40 to 185
o
–40 to 125 C (–40 to 257
ambient temperature
0 to 25 bar, gauge/365 psi, gauge/2500 kPa, gauge (nominal)
0 to 10 bar, gauge/150 psi, gauge/1000 kPa, gauge (nominal)
ambient pressure
o
F)
o
F)
Page EN-3