Select And Start A Washing Programme - Electrolux GS55GLI201 Benutzerinformation

4. To change the setting, press function
button B again, the digital display shows
the new setting.
5. To memorize the operation, switch off the
appliance.
If you decide to revert back to the
use of individual detergents we
advise that you:
1. Deactivate the multitab function.
2. Fill up the salt container and the rinse
aid dispenser again.

Select and start a washing programme

Select the washing programme and
delay start with the door slightly
opened. The start of the programme
or the countdown of the delay start
will occur only after the closure of
the door. Until then it is possible to
modify the settings
1. Check that the baskets have been loaded
correctly and that the spray arms are free
to rotate.
2. Check that the water tap is opened.
3. Press the On/Off button. The dishwasher
must be in setting mode.
4. Press the button selection button to se-
lect the required programme.
The programme number appears in the
digital display (P1 - P2 - P3 etc...) Refer
to 'Washing programmes' chart.
The indicator light of the programme se-
lection button starts flashing.
5. If options are to set, refer to the 'Washing
programmes' chart to be sure that they
can be set with the selected washing pro-
gramme.
6. Close the dishwasher door, the pro-
gramme starts automatically.
The phase indicator lights will go off, ex-
cept for the phase under way.
The digital display shows the running time
of the programme.
The indicator light of the programme se-
lection button remains on with a fixed
light.
Setting and starting the programme with
delay start
1. Once selected the washing programme
and options, press the delay start button
3. Adjust the water hardness setting to
the highest setting and perform 1
normal washing programme without
loading any dishes.
4. Adjust the water hardness setting
according to the hardness of the wa-
ter in your area.
5. Adjust the rinse aid dosage.
until the number of hours for the delay
start appear in the digital display. The
start of the selected washing programme
can be delayed for between 1 and 19
hours.
2. Close the dishwasher door, the count-
down starts automatically.
3. The countdown will decrease with steps
of 1 hour.
4. The opening of the door will interrupt the
countdown. Close the door; the count-
down will continue from the point at
which it was interrupted.
5. Once the delay start has elapsed the pro-
gramme will start automatically.
The selection of the washing pro-
gramme and delay start can occur also
with the door closed.
When you press a programme button
you have ONLY 3 seconds to select a
different programme or a delay start.
After these 3 seconds, the selected pro-
gramme starts automatically.
Warning! Interrupt or cancel a washing
programme in progress ONLY if it's
absolutely necessary.
Attention! Hot steam may escape when
the door is opened. Open the door care-
fully.
Interrupt a washing programme in
progress
• Open the appliance door. The programme
will stop. Close the door, the programme
will start from the point at which it was in-
terrupted.
electrolux 93