What To Do If - Electrolux GS55GLI201 Benutzerinformation

98 electrolux
3. Remove the water inlet and discharge
hoses.
4. Pull the machine out together with the
hoses.

What to do if...

The dishwasher will not start or stops during
operation.
Certain problems can be due to the lack of
simple maintenance or oversights, which can
be solved with the help of the hints described
in the chart, without calling out an engineer.
Fault codes and malfunction
•
appears in the digital display
• intermittent audible signal is active
The dishwasher does not fill with water
•
appears in the digital display
• intermittent audible signal is active
The dishwasher will not drain
•
appears in the digital display
• intermittent audible signal is active
Anti-flood device is activated
Malfunction
The programme does not start
Once these checks have been carried out
switch on the appliance.
The programme will continue from the point
at which it was interrupted.
If the malfunction or fault code reappears
contact your local Service Force Centre.
For other fault codes not described in the
above chart, please contact your local Serv-
ice Force Centre.
Avoid over tilting the machine during trans-
portation.
Switch off the dishwasher, open the door
and carry out the following suggested cor-
rective actions.
Possible cause and solution
• The water tap is blocked or furred with lime-
scale.
Clean the water tap.
• The water tap is turned off.
Turn the water tap on.
• The filter (where present) in the water inlet hose
is blocked.
Clean the filter in the water inlet hose.
• The water inlet hose has not been correctly laid
or it is kinked or squashed.
Check the water inlet hose connection.
• The sink spigot is blocked.
Clean out the sink spigot.
• The water drain hose has not been correctly laid
or it is kinked or squashed.
Check the water drain hose connection.
• Close the water tap and contact your local
Service Force Centre.
Possible cause and solution
• The dishwasher door has not been properly
closed.
Close the door.
• The main plug is not plugged in.
Insert the main plug
• The fuse has blown out in the household fuse
box.
Replace the fuse.
• Delay start has been set.
If dishes are to be washed immediately, cancel
the delay start.
Contact your local Service Force Centre,
quoting the model (Mod.), product number
(PNC) and serial number (S.N.).
This information can be found on the rating
plate located on the side of the dishwasher
door.
So that you always have these numbers at
hand, we recommend you to make a note of
them here: