Select And Start A Washing Programme - Electrolux ESF 66811 Benutzerinformation

90 electrolux
Rinse aid dispenser activated
4. To change the setting, press button B
again, the digital display shows the new
setting.
5. To memorize the operation, switch off the
dishwasher by pressing the On/Off but-
ton.
If you decide to revert back to the
use of individual detergents we ad-
vise that you:

Select and start a washing programme

Select the washing programme and
delay start with the door slightly
opened. The start of the programme
or the countdown of the delay start
will occur only after the closure of
the door. Until then it is possible to
modify the settings
1. Check that the baskets have been loaded
correctly and that the spray arms are free
to rotate.
2. Check that the water tap is opened.
3. Press the On/Off button. The dishwasher
must be in setting mode.
Programme-progress-display is fully on
with a blue light.
4. Press the button corresponding to the re-
quired programme (refer to 'Washing
programmes' chart).
Close the dishwasher door, the pro-
gramme starts automatically.
Programme-progress-display gradually
shows the progress of the washing pro-
gramme.
Setting and starting the programme with
delay start
1. After having selected the washing pro-
gramme, press the delay start button until
the flashing number of hours for the delay
start shows in the digital display.
The start of the selected washing pro-
gramme can be delayed for between 1
and 19 hours.
2. Close the dishwasher door, the count-
down starts automatically.
Only the first LED lamp of the pro-
gramme-progress-display remains on
during the countdown of the delay start.
1. Deactivate the Multitab function.
2. Fill up the salt container and the rinse
aid dispenser again.
3. Adjust the water hardness setting to
the highest setting and perform 1
normal washing programme without
loading any dishes.
4. Adjust the water hardness setting
according to the hardness of the wa-
ter in your area.
5. Adjust the rinse aid dosage.
3. The countdown will decrease with steps
of 1 hour.
4. The opening of the door will interrupt the
countdown. Close the door; the count-
down will continue from the point at
which it was interrupted.
5. Once the delay start has elapsed the pro-
gramme will start automatically.
Warning! Interrupt or cancel a
washing programme in progress
ONLY if it's absolutely necessary.
Attention! Hot steam may escape
when the door is opened. Open the
door carefully.
Interrupt a washing programme in
progress
• Open the dishwasher door; the pro-
gramme will stop. Close the door; the pro-
gramme will start from the point at which
it was interrupted.
Cancel a delay start or a washing
programme in progress
• Simultaneously press and hold the two
function buttons B and C until all the pro-
gramme lights come on.
• Programme-progress-display is fully on
with a blue light.
• Cancelling a delay start will also cancel the
washing programme. You have to select
the washing programme again.
• If a new washing programme is to be se-
lected, check that there is detergent in the
detergent dispenser.
End of the washing programme
• The dishwasher will automatically stop and
an audible signal informs you of the end of
the washing programme.