Multitab Function - Electrolux GS55GLI201 Benutzerinformation

92 electrolux

Multitab function

This appliance is equipped with the multitab
function, that allows the use of the multitab
combi detergent tablets.
These products are detergents with a com-
bined cleaning, rinsing and salt functions.
They can also contain other different agents
depending on which kind of tablets you
choose ('3 in 1', '4 in 1', '5 in 1' etc.).
Check whether these detergents are suitable
for your water hardness. See the manufac-
turers instructions.
Once this function is selected it will remain
active for all following wash programmes.
With the selection of this function the inflow
of rinse aid and salt from each respective
supply container is automatically deactivated
and also the indicator lights for salt and rinse
aid are deactivated.
When using the multitab function, the cycle
duration may change.
Activate/deactivate the multitab function
before the start of a washing pro-
gramme.
Once the programme is running, the
multitab function can NO longer be
changed. If you want to cancel the mul-
titab function you have to cancel the pro-
gramme setting and then deactivate the
multitab function. In this case you have
to set a washing programme (and de-
sired options) again.
4. Close the lid and press until it locks in
place.
Detergent tablets from different manu-
facturers dissolve at different rates. For
this reason, some detergent tablets do
not attain their full cleaning power during
short washing programmes. Therefore,
please use long washing programmes
when using detergent tablets, to ensure
the complete removal of detergent re-
siduals.
Activation/deactivation of the Multitab
function
To activate the Multitab function, press the
Multitab button. Corresponding indicator
light comes on.
To deactivate the function press the Multitab
button again. Corresponding indicator light
goes off.
If the drying results are not satisfac-
tory we suggest that you:
1. Fill up the rinse aid dispenser with
rinse aid.
2. Activate the rinse aid dispenser.
3. Set the rinse aid dosage to position
2.
• The activation/deactivation of the
rinse aid is only possible with the Mul-
titab function active.
Activation/deactivation of the rinse aid
dispenser
1. Press the on/off button. The appliance
must be in setting mode.
2. Simultaneously press and hold function
buttons B and C, until the lights of func-
tion buttons A , B, and C start flashing.
3. Press function button B. The lights of
function buttons A and C go off while the
light of function button B continues to
flash. The digital display shows the cur-
rent setting.
Rinse aid dispenser deactivated
Rinse aid dispenser activated