Select And Start A Washing Programme; Unloading The Dishwasher; Washing Programmes - Electrolux GA60SXV502 Benutzerinformation

Select and start a washing programme

Warning! Interrupt or cancel a
washing programme in progress
ONLY if it's absolutely necessary.
Attention! Hot steam may escape
when the door is opened. Open the
door carefully.
1. Make sure that the baskets have been
loaded correctly and the spray arms are
free to rotate.
2. Make sure that the water tap is opened.
3. Press the on/off button.
4. Set the required washing programme.
Refer to 'Washing programmes' chart for
details.
5. Set, if required, the delay start (refer to
'Control panel').
6. Press the OK button and close the door,
the washing programme will start auto-
matically.
If the delay start has been set, the count-
down will start automatically. Once the
delay start has elapsed the programme
will start automatically.
The opening of the door will interrupt the
countdown. Close the door; the count-
down will continue from the point at
which it was interrupted.
Cancel a delay start or a washing
programme in progress
1. Press simultaneously the option and Ok/
Start buttons.
2. The display shows the message CON-
FIRM CANCEL ?.

Unloading the dishwasher

• Hot dishes are sensitive to knocks. The
dishes should therefore be allowed to cool
down before removing from the appliance.
• Empty the lower basket first and then the
upper one; this will avoid water dripping
from the upper basket onto the dishes in
the lower one.
• Water may appear on the sides and the
door of the dishwasher as the stainless

Washing programmes

3. Press the Ok/Start button to confirm.
4. The appliance returns to setting mode
and the display shows the message
CHOOSE PROGRAMME.
• If a delay start is cancelled also the wash-
ing programme is cancelled.
• If a new washing programme is set, check
that there is detergent in the detergent dis-
penser.
Interrupt a washing programme in
progress
• Open the appliance door, the programme
stops. The display shows the message
PLEASE CLOSE DOOR.
• Close the door, the programme will con-
tinue from the point at which it was inter-
rupted.
End of the washing programme
1. The appliance stops automatically and an
audible signal informs you of the end of
the washing programme.
2. Open the dishwasher door.
The display shows the message PRO-
GRAMME END and PLEASE SWITCH
OFF.
3. Press the on/off button.
Leave the door ajar and wait a few mi-
nutes before removing the dishes. This
way they will be cooler and the drying will
be improved
steel will eventually become cooler than
the dishes.
When the washing programme has
finished, it is recommended that the
dishwasher is unplugged and the
water tap turned off.
electrolux 81